Traceroute to an IP address on Fabric IPsec Gateway VM

About this task

Perform this procedure to traceroute to an IP address on Fabric IPsec Gateway Virtual Machine (VM).

Procedure

  1. Enter Fabric IPsec Gateway Configuration mode:

    enable

    virtual-service WORD<1-128> console

    Note

    Note

    Type CTRL+Y to exit the console.

  2. Traceroute to an IP address:

    traceroute {A.B.C.D}

Example

Traceroute to IP address.
Switch:1> enable
Switch:1# virtual-service figw console
Connected to domain figw
Escape character is ^Y

  <cr>
FIGW> traceroute 192.0.2.100

Variable Definitions

The following table defines parameters for the traceroute command.

Variable Value
{A.B.C.D} Specifies the IP address to initiate traceroute to.
9039040-00 Rev AB